Goal: Recognize forces and the correct free body diagram.
Source: UMPERG
A car accelerates down a straight highway. Which of the free-body
diagrams shown below best represents this situation?
A2L Item 054
Tag Archives: Forces
A2L Item 053
Goal: Hone the concept of force.
Source: UMPERG
Consider three identical blocks as shown below. In case A the block
sits on the bottom of a beaker filled with oil. In case B the block
floats on water. In case C the block is free-falling.
Which block or blocks experience the smallest gravitational force?
- Block A
- Block B
- Block C
- Blocks A and B
- Blocks A and C
- Blocks B and C
- They all experience the same gravitational force
- None of the above
- Cannot be determined
Commentary:
Answer
(7). The gravitational force is approximately the same for all three
blocks assuming that they are about the same height above the surface of
the earth. The gravitational force on an object near the surface of the
earth depends only on the mass of the object.
Background
Students’ models concerning what factors influence a force can be quite
complex. Introducing students to a force law (conceptually or
mathematically) is usually not enough to correct any false associations.
Only through discussion of the force law in a variety of contexts will
the student develop a model more consistent with the physicists’ model.
Questions to Reveal Student Reasoning
What causes the gravitational force? What are some factors that
influence the gravitational force? Make a list. What is the
gravitational force law? Which of the listed factors are contained in
the force law?
Suggestions
What would be the gravitational force on the block if it were sitting on
a table?
Suppose the block was falling through oil or that you dropped the beaker
in case A. Would the gravitational force change?
A2L Item 052
Goal: Reasoning and comparing the sizes of forces.
Source: UMPERGA block attached to the end of a spring is hanging at rest from the
A block attached to the end of a spring is hanging at rest from the
ceiling as shown at the left below. After the block is pulled down and
released it moves up and down for an extended period of time. The
motion during one cycle is shown in the graph at right below.
Several points are indicated on the graph. At which point is the spring
force exerted on the block the greatest?
- Point A
- Point B
- Point C
- Point D
- Points B and D
- Points A and C
- The spring force is always the same
- None of the above
- Cannot be determined
Commentary:
Answers
(4). The spring force is largest at the position where it is compressed
or stretched the most relative to its natural length. The spring is
already stretched when it is at a height H because there must be an
upward spring force to balance the gravitational force on the block. As
the height of the block is decreased the spring is stretched further.
As the height of the block is increased the spring is stretched less –
if raised enough the spring would start to compress.
Background
Many students will attempt to apply the spring force law without real
understanding. This problem requires students to understand the
physical situation and to interpret graphical information about the
height of the block to reason out an answer.
Questions to Reveal Student Reasoning
What is the force law for a spring? How does the spring force compare
to the weight of the block? At what points is the spring stretched? …
compressed?
Suggestions
Demonstrate with a spring that a vertical spring stretches when a weight
is attached. Show that as the weight moves up and down that the spring
need never get back to its natural length (i.e., it is always stretched)
Draw free-body diagrams, especially for points B and D.
A2L Item 051
Goal: Reasoning about the vector nature of force.
Source: UMPERG
A rock sits on a hillside. The slope of the hillside is inclined to the
horizontal at approximately 30°.
Which of the forces exerted on the rock is smallest in magnitude?
- Friction force due to the ground
- Gravitational force due to the Earth
- Normal force due to the ground
- The Friction, Gravitational and Normal force are equal in magnitude
- Cannot be determined
- None of the above
Commentary:
Answers
(1). The smallest force is the friction force. The normal force
balances the component of gravity perpendicular to the hillside and the
friction force balance the component of gravity parallel to the
hillside. Since the hillside has a slope of 30°, the tangential
component of gravity is smaller.
Background
Many students fail to perceive that the static situation implies a
relationship between the forces. They may think that one requires
information such as the mass, and coefficient of friction to compute the
forces before the forces can be compared.
Questions to Reveal Student Reasoning
Can you determine the gravitational force? …normal force? …
friction force? Are there any relationships between these forces? If
so, what are they? Why doesn’t the rock slide down the hill?
Suggestions
Draw a free-body diagram.
Set up a demonstration using a block on a plane with adjustable angle.
A2L Item 050
Goal: Hone the vector nature of force.
Source: UMPERG
A thin wire is stretched horizontally between two walls. If a weight, W,
is hung on the wire, what is true about the tension, T, in the wire?
- T < W
- T = W
- T > W
- The relationship between T and W cannot be determined.
Commentary:
Answers
(3); The vertical component of the tension force exerted on the weight
must equal half the gravitational force. For a nearly horizontal wire
this means the tension must exceed the weight.
Background
The intent is to get students to use their intuitive notions of
balancing force to reason how directions of forces change the value of
forces.
Questions to Reveal Student Reasoning
How do you determine the tension force? What direction does the tension
force point? In (A) what does the tension force equal? Does it matter
what angle the strings point? Explain.
Suggestions
Have some students try to lift an object with strings straight up and at
an angle. Which is easier.
Set up a demonstration with spring scales.
A2L Item 049
Goal: Recognize the presence of a force.
Source: UMPERG
A monkey hangs on a rope. What forces act on the monkey? (Ignore
forces due to the air.)
- Friction, Gravitation
- Tension, Gravitation
- Friction, Tension, Gravitation
- Normal, Friction, Gravitation
- More than one answer is true
- None of the above
- Cannot be determined
Commentary:
Answer
(1); Assuming the monkey hangs from a vertical rope
the only forces can be gravity and friction. Students should realize
that there is only one action-at-a-distance force in this case, that of
gravity, and that there must be some contact force(s) to balance that.
A2L Item 047
Goal: Hone the concept of force, recognize the presence of force.
Source: UMPERG
A water balloon is shown at rest in three different situations. In each
case the water balloon is in contact with a system that supports it.
Which system exerts the largest force on the balloon?
- Spring support in A
- Cardboard and blocks in B
- Table in C
- None of the systems exert a force
- None of the above
- Cannot be determined
Commentary:
Answer
(5). Each system exerts the same magnitude force on the balloon. The
size of the force equals the weight of the balloon.
Background
Context for Use: Give to students before they receive a formal
introduction to interactions.
Assessment Issues: (1) What are students’ naive views about
interactions? (2) Can students perceive when an interaction is
occurring? (3) What factors do students attend to when determining
whether a force is present? (4) What factors do students use to compare
the relative magnitude of two forces?
Questions to Reveal Student Reasoning
Which systems exert a force on the balloon? How did you decide whether
the system exerts a force on the balloon? In each case how did the
force affect the balloon? How did the interaction between the balloon
and system affect the system? When comparing two forces, how can you
tell which force is larger?
Suggestions
Recognizing the presence of an interaction is a difficult problem for
students. One must return to the topic repeatedly as additional
understanding and principles are learned by the students. Initially
focus students on the effects of interaction: (1) Do the motions of the
objects change? (2) Do the shapes of the objects change?
A2L Item 048
Goal: Hone the concept of force, classify forces as contact and action-at-a-distance.
Source: UMPERG
A baseball is struck by a bat. While the ball is in the air, what
objects exert forces on the ball?
- Earth
- Bat
- Air
- Bat, Air
- Earth, Bat
- Earth, Air
- Earth, Bat, Air
- There are no forces on the ball.
- None of the above
Commentary:
Answer
(6); the earth’s gravitational force (an “action-at-a-distance” force),
and air resistance (a contact force) are the only two forces being
exerted on the ball while in the air.
Background
It is common for students to think that motion requires a force; in some
cases this misconception is more specific, namely, that motion requires
a force in the direction of motion. For this assessment item, the
misconception manifests itself in the belief that there is a “force of
the bat” that propels the ball up during flight.
Questions to Reveal Student Reasoning
Ask students to state what forces are being exerted on the ball and what
object exerts each force.
How do you know when a force is being exerted by one object on another?
Do the sizes of the forces change? Do the directions of the forces
change? Describe how.
Do you have any control over the force of the bat on the ball? Can you
make it larger or smaller or change its direction once the ball is
flying through the air?
Suggestions
Ask students if they have a way of exerting a force on an object without
touching it. Invite them to move an object in the front of the room
without leaving their seats and touching the item.
If Newton’s Second Law has been introduced, attempt to relate the forces
exerted on the ball to the ball’s acceleration. See if students agree
that, if air resistance can be neglected, the ball has a constant
acceleration of 9.8 m/s2 toward the earth during its entire
trajectory. If they agree ask what they can conclude about the net
force on the ball while airborne.
A2L Item 046
Goal: Recognize appropriate free body diagram.
Source: UMPERG
A
block of mass 2 kg is at rest on the surface of a wedge that makes an
angle of 30° with the horizontal as shown. The coefficient of
static friction is 0.64 and of kinetic friction is 0.42.
Which figure below best represents the free-body diagram for the block?
6. None of the above
7. Cannot determine the free-body diagram
Commentary:
Answer
(1). The component of the gravitational force parallel to the incline
will balance the frictional force in this situation. The component of
the gravitational force perpendicular to the incline must balance the
normal force.
Background
Even in static situations students can be confused about the relative
sizes of forces.
Questions to Reveal Student Reasoning
What forces are present? What determines how big the gravitational
force is? … the normal force is? … the gravitational force is?
A2L Item 044
Goal: Hone the concept of normal force.
Source: UMPERG
A small ball is released from rest at position A and rolls down a
vertical circular track under the influence of gravity.
When the ball reaches position B, which of the indicated directions most
nearly corresponds to the direction of the normal force on the ball?
Enter (9) if the direction cannot be determined.
Commentary:
Answer
(1) By definition the normal force is always perpendicular to the
surface at the point of contact, independent of the motion of the object
and the shape of the surface. The direction of the normal force is away
from the surface and toward the object in contact with it.
Background
When the normal force is introduced to students, a flat surface is used
to illustrate the concept. Flat surfaces are also used in the majority
of problems that students solve. This item extends the context so that
students consider the normal force exerted on an accelerated object
moving on a curved surface.
Those who answer (8) may be thinking that the normal force always
opposes the gravitational force, as when an object is resting on a
horizontal surface.
Students who answer (5) may be indicating the direction of the normal
force exerted on the curved track by the ball.
Questions to Reveal Student Reasoning
If a ball were on a flat horizontal surface, what would be the direction
of the normal force? What would be the direction of the normal force if
the ball were rolling across a flat horizontal surface? What would be
the direction of the normal force exerted on a block at rest on an
incline? What would be the direction of the normal force on a ball
rolling down an incline?
What direction(s) are perpendicular to the track at point B?
Suggestions
The direction of the normal force is essentially a matter of definition.
The track exerts a force on the ball. Dividing this force into a
component perpendicular to the surface (called the normal force) and a
component tangential to the surface (called the friction force) is a
choice, which is made because it is useful to do so. Definitions are
difficult to get across to students because there are no demonstrations
one can do to show that the normal force points in a particular
direction. The only thing one can verify is how the definition is
applied by students in a diverse set of contexts.
Commentary:
Answer
(4) is the best response. Students often think of the motor as the source of force propelling the car when it is the friction force on the tires that enable the car to move forward. Sometimes it helps to discuss the process of walking on a perfectly slippery surface (ice) to enable students to see the role of friction for forward motion.